Quality judgment of compression fittings

After the compressor equipment is used for a period of time, its compression fittings need to be regularly maintained and maintained. When it is found that the equipment is seriously worn or damaged, it must be replaced in time. Therefore, it is very important to judge the quality of the compressor parts. Early detection of component failures can effectively improve the life of compressor equipment.

How should the quality of the compressor equipment be determined? The following are some of the methods.

The air filter element can be seen from the name. It mainly depends on the paper density and quality of the filter element. It can be seen by the naked eye. If the quality is not good, a lot of impurities and dust will flow into the screw compressor and it will be easy to block. The oil core will produce an internal pressure that is too high, causing the safety valve to open the fuel injection.

How to repair the fuselage damage of the compressor parts

The oil filter is a relatively complicated compressor accessory. It is difficult to identify the quality of the compressor. It is mainly judged according to the time of use. If the alarm is not blocked or the oil pressure is small in the specified time, the exhaust temperature is too high. It may be caused by blockage of the oil filter. After all, the quality of the oil filter is very important. If the quality is not good, it may cause failure in the maintenance of the compressor.

The oil and gas separator is an expensive consumable in the screw compressor. Because of the high cost of this compressor fitting, the price is also high. Generally, the quality of the imported oil separator, the differential pressure ratio and the oil filtering technology are relatively advanced, so it is recommended. In general, the imported oil and gas separator is replaced, and the basic guarantee will not cause oil core failure.

Compressor oil is an essential part of the screw compressor. If there is no compressor oil, the compressor is basically inoperable. We all know that compressor manufacturers do not produce screw compressor oil. Screw compressor oil is one of the oils. There are 8,000 hours of synthetic oil and 4,000 hours of semi-synthetic oil, and 2000 hours of mineral oil are compared. Three common grades. So choosing a good synthetic oil is very important for the compressor.